Re: [ISTA] ALDL Data stream viewing question

[mark.buontempo@bakermotion.com (Mark Buontempo)]

Mike,

I did a run using my scanner and found the desired boost to be :
6.4 psi until the actual boost hit 10 psi then the desired boost went up to
12.6 psi until the actual boost hit 12 psi then it went to 13.8 psi.
This is with the factory chip not sure what you would see on a performance
chip.

Mark


At 10:43 AM 5/28/00 EDT, you wrote:
>I have used a Diacom for the past 9 years or so, and really like it.
>There is data that it does not display howerver.  I was reading that
> the data stream has a byte for boost pressure, then a byte for 
>"desired boost".   I'm looking for a way to plot the two beside 
>each other, maybe with RPM as backdrop, so I know where
>I am when tweaking the wastegate duty cycle params in the
>chip.   Any ideas?  Can I patch the diacom somehow?
>TIA
>Mike V
>